Tie Down Skylight Screens

Tie Down Skylight Screens

Additional information

Skylight screens protect people from falling thru skylights. OSHA Standards (29 CFR 1910.23 and 29 CFR 1910.66 (a)(4)) require all skylights to be protected by compliant screens or railings. To be OSHA compliant, skylight screens must pass a 200-pound load test for most of the USA and a 400-pound force for CAL OSHA Standards.There are many types of skylights, therefore there are many types of skylight fall protection screens. Some screens clamp onto the skylights and do not penetrate the roofing membrane. Others use screws that fasten into the skylights. Some transfer a fall load to the roof. Below are a few skylight types:STS MODEL SKYLIGHT SCREENMounting Frame consists of two extruded 6005-T6aluminum rails that rest on the outside frame of theskylight on its long sides. The aluminum frames areconnected with two 5/16” cold rolled, zinc platedthreaded rods installed on the short sides of theskylight with nylon insert lock nuts and zinc-platedwashers. The screen material is .187 and .250diameter 304 stainless steel or galvanized carbonsteel wire in a 4” X 4” grid. The screen is positioned inthe channel of the aluminum frame and then lockedinto place with 1” aluminum clips attached to the frameusing 1/2” stainless steel hex head screws.SRS MODEL SKYLIGHT SCREENSScreen material is .187 and .250 diameter 304 stainlesssteel or galvanized carbon steel wire in a 4” x 4” grid.The screen rests on the roof surface and is attached tothe skylight frame with vinyl coated stainless steel strapsmounted on the vertical wire grid. Self-tapping screwsfasten the screen to the skylight frame.SSS MODEL SKYLIGHT SCREENSScreen material is .187 and/or .250 diameter 304stainless steel or galvanized wire in a 4” X 4”grid. The larger wire diameter may be used inscreens designed to fit skylights of more than 25”in width. Stainless steel straps and aluminumclamps secure the screen the roof ribs withoutpenetrating the roofing membrane. The clampsare tightened to the ribs with set screws.SCS MODEL SKYLIGHT SCREENSScreen material is .187 galvanized carbon steelwire in a welded 4” X 4” grid, flat with an overallsize of 40” x 128”. Support Channels are 128” inlength and are formed to fit over standard ribbedor corrugated profiles. Channels rest on two ofthe skylight panel major ribs and are positionedlengthwise beyond the ends of the installedskylight and are attached through the roof to thesteel or wood building purlins with suppliedfasteners. The screen is attached at the sametime using metal clips included in the kit.Contact us today for you skylight screen needs or fill out the form below and email to theharnessdepot.com@gmail.comSkylight Screen Order Form  

Related products
Guardrail

Tie Down Wheeled Adjustable Guardrail Gate and Latch Kit

$575.00
Details
Guardrail

Tie Down 10ft RZ Guardrail High Strength Low Alloy Steel Yellow TS22

$222.00
Details
Guardrail

Tie Down Zip Base- 3 Hole Base Pre-Galvinized with Rubber Feet

$315.00
Details